SNOWDOGG VX 85 VX95 HANDHELD CONTROLLER NEW!!

Description: A New Handheld Control for the SnowDogg V Plows Gen 1.This is far better than the factory controller. To save money, SnowDogg attempted to make the V Plow and Expandable Plow run off the straight blade controller - a terrible design to try and operate. This controller has dedicated buttons and is back lit for night plowing. The V plow does not have the same soft stop as the other blades. This has the correct plugs on it - no adapters. Plugs right into and replaces the factory 16161600 control. This has a 12-pin plug. This control uses only 1 button for every function. This works on all their Gen 1 V Plows: XV, VMD and HV.This will not work on the Generation 2 v plows. The newer v plows have a square 12 pin connection, this one has the rectangular 12 pin for the Generation 1 only. Please check your plug if you aren't sure.If you have a Generation 2 plow, you will also need control adapter 16160372.V Plow Aftermarket Control Instructions.Aftermarket Control U-Set Instructions.Control plugs directly into your existing harness, NO adapter required, just Plug-N-PlowPlease make sure the connector matches your connector before orderingAutomatic Shut-off when not in use, approximately 22 minutesExpress Up/Down FeatureOn/Off switch can be used as an Emergency Stop when requiredIlluminated keypad on control for night time plowingAll control functions will time out (shut-off) after a period of time. This helps reduce wear on the pump motor and prevent unnecessary battery drain, Up-button, times out after 2.6 seconds, while left and right functions time out after 3 secondsFlexible Straight CordUse for both Left or Right HandDash Mount Control Holder IncludedInstructions come with each controlDesigned and Manufactured in the U.S.A.

Price: 266 USD

Location: Jamaica, New York

End Time: 2025-01-14T23:32:27.000Z

Shipping Cost: 0 USD